Another advantage is cost-effectiveness
- In use, it can be well used to control its soft and hard degree in the annealing process, mainly used in the construction industry as a binding wire and binding line. Of course, its use is not limited to arts and crafts, but also widely used in the construction industry. Earlier woven lanterns were made of iron wire with appropriate candles placed inside. People hung them in front of their doors and looked very beautiful at night.
On the highway, the barbed wire protective net is generally used to prevent people and animals from crossing the highway at will, so as not to interfere with driving and reduce accidents, as well as effectively prevent illegal occupation of highway land and other issues of traffic safety facilities. There are many forms of barbed wire protective nets, commonly used are metal, woven nets, barbed wire and evergreen green gracilaria. In the densely populated areas set up metal woven net, people and animals are less sparse areas of the form of barbed wire, in the toll station, service area and other sections of the structure of hedge and barbed wire. In the past two years, considering the aesthetic problem, some highways in the Pearl River Delta region adopted the fruit plastic spot welding mesh (usually said guardrail mesh), the barbed wire protective mesh is more beautiful, but also durable, the overall effect is good, but the construction requirements are higher, more expensive. General sections should not be used, in the city center, scenic spots or strong requirements for beauty of the section available.
- (2) Greenhouse special electric galvanized shaft wire shall not be used for waist hoop compression reinforcement, usually not used for all binding.
- The third is the service life.
- The mixture of rare earth and aluminum enhances the fluidity of zinc liquid, makes the coating more uniform, and also reduces the zinc consumption. Hot dip galvanized wire has better protection performance than cold galvanized wire, which makes it good application in chemical experimental equipment. Hot dip wire coating thicker, so that it has good corrosion resistance, can be in the outdoor sun and rain and other harsh environment can be maintained for decades, so hot dip galvanized wire is widely used in construction, traffic guardrail and other outdoor facilities.
- 2, line diameter, mesh spacing (refers to the edge of the twist to the opposite side of the distance).
- The breeding galvanized electric welding net is still in the construction project and has been well used. It is because of such a network, so now in the construction project, can save more time and effort. Not only in this industry, such as breeding and breeding in nursery stock and supermarket shelves, have started to use such nets, to meet the needs of the industry, and can also well help people in their jobs.
- If the requirements are not high, and the ventilation is good, and relatively dry place, it is recommended to use electric galvanized barbed rope, because the price of this product has a certain advantage, for ordinary users, this is a more appropriate product.
Pressure lock steel grid plate is at each intersection of bearing flat steel and horizontal bar, the horizontal bar is pressed into bearing flat steel or pre-slotted bearing flat steel through the pressure, the fixed steel grid plate, called pressure lock steel grid plate. The cross bar of the pressure lock steel grid plate is usually flat steel.
Because the coating obtained is thicker, hot-dip galvanizing has very good protective function than electric galvanizing, so it is an important maintenance coating for iron and steel parts in strict working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transportation, shipbuilding and other occupations. In the field of agriculture, such as pesticide irrigation, greenhouse and construction industry such as water and gas transportation, wire casing, scaffolding, Bridges, highway guardrail and other aspects, it has been widely used in these years.
- The application range of small hexagonal net is also relatively wide, can be used for building wall fixed insulation layer, pipeline, boiler fixed insulation, decoration and other fields.
The common weight standard of galvanized barbed rope is 25kg per coil, and the length of each coil varies from 220-250 meters according to the specifications of the barbed rope. And of course we all know that the heavier the disc the longer it is. But there is one point that is worth our attention, that is, the hollow inside the general larger disk is relatively small, and the hollow inside the lighter galvanized thorn rope is relatively large. The purpose of this is to reduce the number of bending of the thorn rope and make it easier and more beautiful when installing, on the other hand, it looks larger in appearance.
- “Wet” hot dip galvanizing is also called “molten solvent method” hot dip galvanizing. Iron and steel workpiece through degreasing, pickling and cleaning, it is necessary to set in a special box above the surface of the molten zinc in the “molten solvent” (also called cosolvent), and then into the zinc liquid to galvanized. The molten solvent is usually a mixture of ammonium chloride and zinc chloride, but also other chlorine salts.
- 2.25*2.25mm 10 meters per kilogram
- The common barbed rope produced by the manufacturer is the 14*14 type of barbed rope product. Since the warp wire used is the same as the wire diameter of the barbed rope, it is easier to calculate the length and weight. Usually each kilogram of barbed rope can reach about 10 meters of service length. The length of each kilogram of raw material is about 35 meters. Since 35 meters of raw material wire diameter can produce 10 lengths of barbed rope cost.
There is in place to use, the blade thorn rope is commonly border, installation and use of the fence, and prisons, and galvanized barbed wire is in the orchard, fence livestock and so on the installation of large area, although the use of relatively large, but not as good as the use of blade thorn rope and high grade, so this is also the main reason for the price is quite high. Finally, the general installation site of the blade barbed rope for the protection level requirements are relatively high, so the quality requirements for the product is also relatively high, but the ordinary galvanized barbed rope because of the requirements in the installation site is more casual, which is also for the processing process for the quality requirements are relatively low.
Field fence line net is a streamlined, streamlined, beautiful, tacky, fashionable European elegance; The diversity of color selection, a variety of standard color card colors to choose from, can meet different varieties, different, different needs. On-site fence line can be separated from a variety of methods, and according to the customer’s disagreement request.
The production process of stainless steel blade barbed wire is basically similar to that of galvanized blade barbed wire, and the blade size is usually determined according to the mold.
Post time: 11-05-23- Weaving process: plain grain
- The strength, service life and hardness of positive and negative twisting rope are good. The tensile strength of steel wire is 1200N and that of iron wire is 350N. This service life is much longer than ordinary wire barbed rope.
The barbed rope produced by the barbed rope factory adopts the way of winding in order to facilitate transportation, and the disk weight of the galvanized barbed rope is different according to the size.
In GENERAL, THE HARDNESS OF A METAL IS OFTEN CONSIDERED AS THE RESISTANCE OF a MATERIAL TO COMPRESSION PLASTIC deformation, scratches, wear, or cutting. In the adjustment of zinc dip distance of galvanized wire, keep the original speed unchanged, according to the time of zinc dip, wire diameter, and then estimate the zinc dip distance. By adjusting the zinc dipping distance, the zinc dipping time of various specifications of steel wire is shortened by 5s on average compared with that before debugging, so that the zinc consumption is reduced, the zinc consumption per ton of steel wire is reduced from the original 61kg to 59.4kg.
- The acceptance of cold-drawn low carbon steel wire shall be conducted according to the same production unit, the same raw material, the same diameter, and shall not exceed 30T for an inspection lot, and check the base material into the factory or out of the inspection statement. The inspection items for each inspection lot are appearance quality, diameter error, tensile test (including tensile strength and elongation) and repeated bending test.