-40 °C to + 90 °C

Standard petroleum oil has a lifespan of 30 years at 86 degrees Fahrenheit if it’s not 

Vulcanizates of several fluoroelastomers, listed in Table 14.1, were exposed to a standard 5W-30 engine oil, ASTM Service Fluid 105, for up to 6 weeks at 150°C (302°F).⁵ The oil was changed weekly, but was not aerated. Retained elongation was measured after exposure for 1, 2, 3, and 6 weeks; data are shown in Fig. 14.3. The results indicate that bisphenol-cured FKM-A500 VDF/HFP copolymer, FKM-B600 VDF/HFP/TFE terpolymer, and peroxide-cured FEPM-7456 TFE/P/VDF terpolymer lost most of their original elongation over the course of the test exposure, indicating considerable additional cross-linking occurred by reaction with amine- and phenol-containing oil additives. The other fluoroelastomers showed better retention of elongation, being much less susceptible to additional crosslinking. Note that FEPM-7456 contains a high level of VDF (about 30%), while FEPM-7506 contains a relatively low VDF level (10–15%) to serve as cure site for bisphenol curing. The other FEPM types contain no VDF.

Renault/BPW

Entry of dust and debris is one of the most common reasons oil seals fail. For instance, in high-pressure applications, even the smallest sediments can create a gap in the seal, causing the oil to leak and dirt to get in.

Please see the following for the types of sealing devices for bearings.
How to Select the Right Bearing (Part 7): Components surrounding the bearing

You have to consider the speed at which the shaft will be moving, the housing bore, and the runout. These are important to make sure that you choose an oil seal that will not be exposed to unconducive abrasions.

Importance of Quality Oil Seals in Automotive Applications: