1
* Skin Health Bamboo's natural antimicrobial properties can help reduce the risk of acne and other skin irritations, while its softness can help prevent bed sores and other pressure injuries
Because of its light weight, strength is relatively large has gradually begun to replace the original column. At the same time, due to the relatively uniform specifications, the barbed rope installation is also more beautiful. The direct spacing of the barbed rope is relatively fixed, which can effectively prevent crossing. At the same time, the mesh at the bottom is relatively dense, while the mesh at the top is relatively loose, which can save resources.
Hexagonal mesh is based on wire mesh prepared by metal wire, wire diameter of 0.3-2.0mm metal wire. Hexagonal mesh is a good choice for breeding cage, he is through hot dip galvanized or PVC coated plastic disposal, the structure is tightly combined with no bump and convex appearance. Keep chickens and ducks, isolate chicken and duck houses, and try to take care of poultry.
Post time: 23-04-23
Post time: 01-08-22
Post time: 19-04-23The characteristics of these cages are small, light, easy to carry and easy to clean. For small animal cage, the wire diameter of the general iron wire is not very large, the thickness of the plastic is relatively thin, so the use of the time can not be “violence”, otherwise the cage in the “destruction” will occur under the welding or plastic crack.
Post time: 08-08-22Compared with galvanizing, hot-dip galvanizing has lower production cost and less environmental impact than galvanizing. Because the coating obtained is thicker, hot-dip galvanizing has better protective performance than electric galvanizing, so it is an important protective coating for steel parts used in harsh working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, ocean exploration, metal structure, electric power transmission, shipbuilding and other industries.
- If the connection near the installation is not completely aligned, then the installation has been aligned, and then the rest of the attachment installation, it will be relatively simple, and then install the blade thorn rope, installation of blade thorn rope must be the blade thorn rope with a clip card below the guardrail. And this will not damage the purse Seine, after the installation of the accessories, the guardrail is also equal to the installation, and then check the fixing of the screws, to determine that there is no problem after.
- 2, oil: it is recommended to use cloth (there is a kind of textile cloth for polishing glasses, do not knit, because the nap is easy to fall off), oil to the inside and outside of the cage. The amount of oil is not much, because the bamboo material is old, density and hardness are relatively high.
Post time: 30-08-22- (4) can withstand a large range of deformation, but still do not collapse. Play the role of fixed thermal insulation;
Any application environment, users want a better the strength of the welded wire mesh, only need to improve its intensity, will make better the habit of using demand, but to be improved in the strength of this product, also need yo have a variety of conditions, will need to see factory in produce what kind of material, the strength of the product also is the material strength, But a manufacturer in the data does not fit the strength requirements, after all, there is no way to make the strength of the product progress, so this is the condition to.
Post time: 28-02-23- In addition to these reasons, we should also pay attention to the tooling and process must be stable, and regular testing should be done to ensure the uniformity of galvanized layer.
- In the process of composite plating, it is necessary to stir the plating solution to obtain the composite coating in which the particles dispersed in the matrix metal. Stirring methods include mechanical stirring, air stirring, ultrasonic stirring, bath circulation, etc. In the process of production, the acid activation solution can remove the corrosion products and oxide film on the surface of low carbon steel wire without excessive corrosion on the matrix. Galvanized wire can be used zincate galvanized or chloride galvanized and other processes, appropriate additives should be used to obtain the coating required by the standards of low carbon steel wire.
Post time: 14-06-24- Take the blade cord for example, the quality of the cord and the shape and direction of the surface barbs are what consumers need to consider. Professional materials in use can meet the needs of most consumers for materials, and the quality of these products is certainly to withstand the test, so if you really can not make up your mind, choose what kind of barbed rope, it is recommended to choose the best blade barbed rope.
- (4) Stop the use of more than two strands of galvanized iron wire around the operation method.
Cold drawing wire is a metal cold processing, with wire rod as raw material, that is, the mouth of the steel bar. Cold drawing wire is a product produced by a series of processes such as shell stripping, which is a common wire. In the development and production of metal materials, cold drawing wire is a very common material, its performance is good, the range of use is very wide, manufacturers in processing are the use of cold processing to produce.
- Electric welding mesh can be made into the form of mesh, mesh surface can be used to dip plastic or spray plastic process, forming a layer of protective film on the surface of electric welding mesh, can effectively make the wire and the outside of the water or with corrosive substances isolation, can achieve the effect of increasing the use of time, can also make the mesh surface show different colors, so that the mesh to achieve beautiful effect. Impregnated mesh is usually used for outdoor, and column link, can play a protective anti-theft effect.
- Steel mesh benefits: Compared with traditional handmade steel mesh, steel mesh has better elasticity and even spacing. When pouring concrete, the steel mesh is not easy to bend, and the thickness of concrete protective layer is easy to control and even. In bridge deck surfacing, measure the protective layer of steel mesh. The pass rate is 95 percent.
Every time galvanized wire production enters the peak season of the industry, the road leading to the factory will see from time to time transport wire and container vehicles, as well as galvanized bright wire short-distance transport trucks, driving the labor utilization rate in the surrounding countryside, solving the employment problem of most people. Galvanized wire is divided into hot dip galvanized wire and cold galvanized wire difference: hot dip galvanized is in the heated melting zinc liquid dip plating, production speed is fast, the coating is thick but not uniform. Dark color, consumption of zinc metal, and matrix metal formation of infiltration layer, good corrosion resistance, hot dip galvanizing in outdoor environment can be maintained for decades.
- Galvanizing refers to the surface treatment technology of plating a layer of zinc on the surface of metal, alloy or other materials to play the role of aesthetics and rust prevention. The main method used now is hot galvanizing. However, hot dip galvanizing industry has been developed with the rapid development of cold strip rolling in the past 30 years. The production process of hot-galvanized sheet mainly includes: raw plate preparation → pre-plating treatment → hot-dip plating → post-plating treatment → finished product inspection and so on.
Post time: 09-05-23- Suitable for general engineering building wall, pouring concrete, multi-storey building, etc., in the structure of heat preservation and heat insulation system plays an important role, when the construction will be hot dip galvanized welded wire rack together wall of heat preservation and heat insulation board placement will be concrete pouring mold inside, outside the wall heat preservation and heat insulation board and one kind of live, after ripping into heat preservation and heat insulation board and wall body. The coating on the surface of the welding core is called the coating.
- Stainless steel wire drawing is a metal processing (stainless steel) process, is a popular surface treatment technology in stainless steel and aluminum products industry today. It is a wire drawing effect treatment for stainless steel and aluminum products. So galvanized wire and stainless steel wire are two different products. In order to remove the surface film and surface inclusions on the surface of the deposited layer, the defects can be found and treated by conventional techniques. Excess foam is caused by soap and surfactant saponable fats brought into the tank.
Post time: 31-08-22These citizens, who love the subway, rely on it and enjoy its speed, often like to call themselves the U-pin price. Is widely used in industry, agriculture, farming, construction, transportation and other welded wire mesh is used in the field of high quality low carbon wire line of welding and become, then after cold, hot dip plating, PVC plastic coated surface passivation, such as plasticizing processing, production of metal mesh with smooth surface, uniform mesh, solder joint is firm, stability, corrosion resistance, good corrosion resistance characteristics. The U nail price is made of high quality stainless steel wire row welding; For example, machine protective cover, animal animal fence, flower fence, window guard bar, channel fence, poultry cage and home office food basket, paper basket and decorative articles, more acid, alkali, welding firm, beautiful and other characteristics.
- Compared with the traditional braided barbed rope, the blade barbed rope has a relatively complex technology and a relatively high cost of raw materials.
- Three, the use of different technologies