Although barium sulfate is almost completely inert, zinc sulfide degrades upon exposure to UV light, leading to darkening of the pigment. The severity of this UV reaction is dependent on a combination of two factors; how much zinc sulfide makes up the pigments formulation, and its total accumulated UV exposure. Depending on these factors Lithopone B301, Lithopone B311 powder itself may vary in shade over time, ranging from pure white all the way to grey or even black. To suppress this effect, a dopant might be used, like small amount of cobalt salts, which would be added to the formulation. This process creates cobalt-doped zinc sulfide. The cobalt salts help to stabilize zinc sulfide so it will not have as severe a reaction to UV exposure.

According to Procurement Resource, the prices of titanium dioxide are expected to showcase mixed sentiments. With trade and supply-chain normalization, the automotive and construction sectors are estimated to improve their global performance, thus affecting the prices positively.

Lithopone or sulphide of zinc white has been in general use for twenty years or more in many industries where a white pigment of considerable body or hiding power is required that is not subject to change like lead carbonate and has not the brittle character of zinc oxide, besides being sold at a lower figure than either of these. Nevertheless it is still comparatively new to the general painting trade. Because of our tariff protection its manufacture in this country has made great progress. Yet in spite of this and the duty imposed on it, the imports are still in excess of the quantity manufactured here. A short history of its origin will no doubt prove of interest to our readers.

Pigment White 5; CI 77115; Deckweiss (Deut.); Lithopone (Deut.); litopón (Esp.); lithopone (Fr.); lithoponio (Gr.); litopone (It.); lithopoon (Ned.); litopone (Port.); Orr's white; oleum white; Griffiths zinc white; Sterling white; Albalith; Charlton white; Ponolith; Jersey Lily white; Sunotlith; Beckton white; Zincolith

Faber argued there hasn't been enough change in these federal regulations in the decades following the FDA's approval of titanium dioxide – especially as others increasingly point to potential health consequences.

They are the only two sunscreen ingredients classified by the FDA as safe and effective. And though titanium dioxide is usually used in mineral sunscreens in the form of nanoparticles, evidence suggests that few, if any, particles penetrate the skin.

In addition to pigments and sunscreens, titanium dioxide is also used in the production of paper, food products, and pharmaceuticals. In the paper industry, titanium dioxide is added to paper coatings to improve brightness, smoothness, and printability. In the food industry, titanium dioxide is used as a whitening agent in products such as candies, chewing gum, and icing. In the pharmaceutical industry, titanium dioxide is used as a coloring agent in tablets and capsules.

It turns into light gray after being exposed to ultraviolet rays in sunlight for 6 to 7 hours, but it will return to its original color when placed in a dark place. It is easy to oxidize in the air and then agglomerate and deteriorate when exposed to moisture.

We know that there are a lot of suspended organisms and colloidal impurities in natural water. The forms of suspended solids are different. Some large particles of suspended solids can settle under their own gravity. The other is colloidal particles, which is an important reason for the turbidity of water. Colloidal particles can not be removed by natural settlement, because colloidal particles in water are mainly clay with negative electricity The Brownian motion of colloidal particles and the hydration on the surface of colloidal particles make colloidal particles have dispersion stability. Among them, electrostatic repulsion has the greatest influence. If coagulant is added to water, it can provide a large number of positive ions and accelerate the coagulation and precipitation of colloid. Compressing the diffusion layer of micelles makes the potential change into an unstable factor, which is also conducive to the adsorption and condensation of micelles. The water molecules in the hydrated film have fixed contact with the colloidal particles and have high elastic viscosity. It is necessary to overcome the special resistance to expel these water molecules. This resistance hinders the direct contact of the colloidal particles. The existence of some hydrated films depends on the electric double layer state. If coagulant is added to reduce the zeta potential, the hydration may be weakened. The polymer materials formed after coagulant hydrolysis (the polymer materials directly added into water generally have chain structure) play an adsorption bridging role between the colloidal particles. Even if the zeta potential does not decrease or does not decrease much, the colloidal particles can not contact each other and can be adsorbed through the polymer chain Colloidal particles can also form flocs.

This constant high rate of ROS production leads rapidly to extreme macromolecular oxidation, here it is observed in the AOPP and MDA detected after 3 h in samples treated with bare P25TiO₂NPs (Fig. 6, Fig. 7). Macromolecular oxidation includes, among others, both protein and lipid oxidation. The ROS causes protein oxidation by direct reaction or indirect reactions with secondary by-products of oxidative stress. Protein fragmentation or cross-linkages could be produced after the oxidation of amino acid side chains and protein backbones. These and later dityrosine-containing protein products formed during excessive production of oxidants are known as advanced oxidation protein products (AOPP). They absorb at 340 nm and are used to estimate the damage to structural cell amino acids. Lipid oxidation is detected by the conjugation of oxidized polyunsaturated lipids with thiobarbituric acid, forming a molecule that absorbs light at 532 nm. Polyunsaturated lipids are oxidized as a result of a free-radical-mediated chain of reactions. The most exposed targets are usually membrane lipids. The macromolecular damage could represent a deadly danger if it is too extensive, and this might be the case. Moreover, it could be observed that cellular damage continues further and becomes irrevocable after 6 h and MDA could not be detected. This may be due to the fact that the lipids were completely degraded and cells were no longer viable. Lipids from the cell membrane are the most prone to oxidation. In fact, lipid peroxidation biomarkers are used to screen the oxidative body balance [51]. At the same time, AOPP values are up to 30 times higher for bare nanoparticles in comparison to the functionalized ones.

Reasons for listing: Henan Billions Chemical Co., Ltd., a well-known brand of TiO2 factory, a famous trademark in Henan Province, a listed company, a drafting unit of national and industry standards, a high-tech enterprise, advocating the implementation of clean production, focusing on titanium and zirconium fine powder A large-scale inorganic fine chemical enterprise engaged in material R&D and manufacturing.

Journal Information

Titanium dioxide, or TiO2, sometimes referred to as E171, is an inorganic, solid substance used in a wide range of consumer goods including cosmetics, paint, plastic and food, according to the American Chemistry Council.

In 2021, the European Food Safety Authority concluded that titanium dioxide is no longer safe in foods due to the same concerns over nanoparticles. As a result, titanium dioxide is now banned as a food additive in the EU. Although studies have shown that the absorption of ingested titanium dioxide is low, evidence suggests that titanium dioxide nanoparticles can accumulate in the body over time. Health Canada deemed it safe in 2022 but noted concerns. Unlike their European counterparts, Canadian officials did not consider studies performed with titanium dioxide nanoparticles alone. 

Some people have concerns about the safety of titanium dioxide because of reports linking it to cancer.

≥ 5 % of standard sample