Look at the end of the sump. If you cannot see clearly whether you need to remove the engine, consult a car service manual or dealer.

Oil Seal Part Number System

Leather is probably the oldest of the lip materials still in common use, but the move towards mass production methods has seen a massive increase in the development of synthetic rubbers which lend themselves to accurate and repeatable injection and compression moulding. Nitrile (NBR) is still by far the most common elastomer for “normal” use, whilst Viton® (FKM/FPM) is rapidly replacing Polyacrylate (ACM) and Silicone (VMQ) for high-temperature applications. Viton® also has high resistance to abrasion and chemical attack making it a preferred elastomer. Recent developments in the use of PTFE for Rotary shaft seals has caused widespread interest particularly for high-speed shaft rotation or poor lubrication applications.

Many – too numerous to list, covering a vast range of designs, sizes, and materials suitable for a never-ending range of applications. Some designs conform to International Standards such as BS1399 and DIN 3760 for metric sizes and seal types, but the majority have been manufactured to suit particular applications – hence the enormous selection available. This blog is intended to assist in this selection and will consider seal type, materials, and sizes.